TBS Oblivion GPS Addition - Change of Firmware Needed

TBS Oblivion GPS Addition - Change of Firmware Needed

Please see the video link at the bottom of this page for additional help

Using the BN-180 GPS Module and the TBS Oblivion stack, you will want to do the following:

1. Leave the wire colors from the BN-180 plug untouched (see below):

BN-180 GPS Wiring Diagram from Cyclone FPV

Then make sure to change the wiring for the other end of the plug to match the TBS input (see below)

TBS Oblivion GPS Wiring with BN-180 from Cyclone FPV

You will then need to downgrade your firmware to BF 3.1.7 (click here to download)

Once you have done this and flashed the FC, make sure to do the following:

1) In the ports tab select GPS under UART3 Sensor Input (57600) - Then save

2) Go to the Configuration Tab and make sure to change the protocol to UBLOX and ground assistance to North America. After that you will be working.Ā 

Share this post...
Previous post