Hobbywing Xrotor Micro 45A 6S 4 in 1 ESC Dshot1200 from Cyclone FPV
The Hobbywing Xrotor Micro 45A 6S 4 in 1 ESC Dshot1200. A powerful ESC with 32bit BLHeli capabilities.Tons of power, with reliable performance.
High performance 32-bit microprocessor with the running frequency of up to 48MHz for excellent performance.
BLHeli_32 firmware is the third generation BLHeli, following base BLHeli and BLHeli-S.
All codes use damped light mode. Damped light does regenerative braking, causing very fast motor retardation, and inherently also does active freewheeling.
The code supports features to prevent sync loss. There are tunable parameters that can make the code run well even in the most demanding situations, although default settings will work excellently in normal operating environments.
The code supports regular 1-2ms pulse width input, as well as Oneshot125 (125-250us), Oneshot42 (41.7-83.3us) and Multishot (5-25us).
Dshot signaling is supported at any rate up to at leastDshot1200. The input signal is automatically detected by the ESC upon power up.
The code also supports a beacon functionality, where the ESC will start beeping after a given time of zero throttle. This can be very useful for finding lost crafts.
On board 10V &5V BEC , powering different accessories such as FC , VTX,Camera and LED lights and etc.
XRotor Micro 45A 4in1 BLHeli32 6S
FPVs with 130-280mm Diagonal Wheelbase
LiPo Power input
5V@1.5A / 10V@1.5A
No wires but solder tabs
XT60 (w/ Wires Soldered on) /no
Weight / Size
11.5g / 32.7x18.4x6.2mm
* Note: All the wire length above is the original length, not the length you see from the outside.
This Hobbywing Xrotor ESC is part of the combo package which you can purchase here. If you are ordering only the ESC, the package will be sent to you with the following items (please see the photo below for verification)
1 Hobbywing Xrotor 45A ESC *
1 Hobbywing XT60 w/wire combo *
2 Hobbywing capacitors *
1 Hobbywing ribbon cable for ESC/FC connection *
1 Hobbywing ESC Manual
4 30mm M3 Screws
4 3mm Nylon Standoffs
4 M3 Lock Nuts
(note: items with the * are items that are included in the combo package from Hobbywing and are intended for the ESC. The screws, nylon standoffs, and lock nuts are provided by Cyclone FPV so that we can leave the original screws, standoffs, and lock nuts with the Hobbywing Xrotor Flight Controller)